These step-up/step-down regulators take an input voltage from 3 V to 30 V and increase or decrease it as necessary to produce an adjustable 4 V to 12 V
The ENABLE pin can be used to put the board in a low-power state that reduces the quiescent current to between 10 and 20 µA per volt on VIN (e.g. approximately 30 µA with 3 V in and 500 µA with 30 V in).
This regulator has built-in reverse-voltage protection, over-current protection, thermal shutdown (which typically activates at 165°C), and an under-voltage lockout that causes the regulator to turn off when the input voltage is below 2.5 V (typical).
Size 44mm x 22mm x10mm
|Minimum operating voltage:||2.9 V|
|Maximum operating voltage:||32 V|
|Maximum output current:||2 A|
|Minimum output voltage:||4 V|
|Maximum output voltage:||12 V|
|Reverse voltage protection?:||Y|
|Maximum quiescent current:||5 mA6|
Are you having trouble with the tails on your XT60 Then these are what you...
Buzzer for Flight Control Board. Battery warning and Flight Controller status signals when connected correctly....
XT60 Connectors. Male and Female Plugs