Billy Wilds Personal Collection of FPV Products .

Full Metal Racing Kakute F3 Flight Controller V1.0

The new  Kakute Flight Controller is here. Packed with great features and is easy to install.  Great for those tight stack height builds being only 6mm high. The 6050 Gyro is much more forgiving with vibrations, making this a great choice for your next build. The other very useful feature is that this board is 2s to 6s capable. Just power straight off the battery or take a feed off your 12v port on the your PDB.

Manual Available Here - Download


  • Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Extremely low profile design.
  • Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.
  • Cleanflight support (RACE target).
  • BLHeli flashing supported by hardware
  • Raceflight ready
  • Betaflight ready



  • STM32F303CCT6(256kB flash) 32-bit processor
  • MPU6050 Gyro/Accelerometer
  • High quality, gold plated PCB
  • Micro USB connector for programming
  • Dimensions: 36x36x6mm (includes USB in height)
  • Mounting Holes: 30.5mm square to center of holes
  • Weight: 4.2g


Collections: Board

Category: F3 FC, Flight Control, FMR

Type: Boards

Related Items

Customer Reviews

Based on 1 review Write a review